Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 05 ELECTRICAL SYSTEM Subsection 06 (DIGITALLY ENCODED SECURITY SYSTEM (D.E.S.S.)) If programming is complete, write the changes to the ECM. Refer to WRITING CHANGES TO ECM in this subsection. After the write operation, remove key from D.E.S.S. post. Try the key(s) on the watercraft. Erasing All Keys Click on Erase All Keys button at bottom of screen. Setting Maximum Speed for Learning and Rental Keys NOTE The maximum speed setting chosen will be applicable to any programmed Learning or Rental keys. Changing key setting is only available when the engine is not running. A programmed normal D.E.S.S. key is required to set the Learning or the Rental key.

To change Learning or Rental Key settings, carry out the following: 1. Briefly press the START button to wake up the electrical system. smr2009-035-004_b 1. Click on this button NOTE: No message will be displayed in B.U.D.S. When done, add at least a new key to the vehicle. Refer to ADDING A KEY in this subsection. If programming is complete, write the changes to the ECM. Refer to WRITING CHANGES TO ECM in this subsection. Writing Changes to ECM Save the changes made in B.U.D.S. into the ECM as follows. Briefly press the START button to prevent ECM communication interruption during the write process. Do not hold START button to avoid engine cranking . Click the Write Data button.

sdd2009-001-019_e 1. START button 2. Wait for the information center to complete its self-test. 3. Install a programmed normal D.E.S.S. key to watercraft D.E.S.S. post. 4. Press the MODE button repeatedly until KEY MODE is visible in the information center. NOTE: If for some reason the writing operation fails, exit B.U.D.S. Restart B.U.D.S. and reenter all the previously lost information. vmr2006-012-100_ben 328 smr2009-035