Section 05 ELECTRICAL SYSTEM Subsection 06 (DIGITALLY ENCODED SECURITY SYSTEM (D.E.S.S.)) D.E.S.S. Key on Post Probe D.E.S.S. post terminals to check continuity as follows. smr2009-035-001_b smr2009-042-005_b 1. 8-pin connector here Set multimeter to . Probe D.E.S.S. post terminals to check continuity as follows. smr2009-035-002_a Reconnect D.E.S.S. post connectors. If any continuity test fails, replace D.E.S.S. post. D.E.S.S. Post Vehicle Harness Continuity Test Disconnect the 8-pin connector attached to the vehicle harness of the D.E.S.S. post. smr2009-035-008_a smr2009-042-005_b 1. 8-pin connector here Disconnect the "B" connector from ECM. Refer to ELECTRONIC FUEL INJECTION subsection.
Install the ECM ADAPTER TOOL (P/N 529 036 166) on ECM connector. Probe vehicle harness terminals to check continu- ity as follows. smr2009-035-001_a smr2009-035 331 8-PIN CONNECTOR D.E.S.S. POST HARNESS RESISTANCE @ 20°C (68°F) Pin 3 Pin 5 Close to 0 8-PIN CONNECTOR D.E.S.S. POST HARNESS RESISTANCE @ 20°C (68°F) Pin 3 Pin 5 Open circuit 8-PIN CONNECTOR D.E.S.S. POST HARNESS RESISTANCE @ 20°C (68°F) Pin 4 Post terminal Close to 0 8-PIN CONNECTOR D.E.S.S. POST HARNESS RESISTANCE @ 20°C (68°F) Pin 3 Post ring Close to 0