Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 07 BODY AND HULL Subsection 02 (BODY) BODY COVER ssi2009-003-004_a LH SIDE SHOWN 1. Remove this plastic push-in clip smr2009-042-057_a 1. Body covers 6. Open seat and using a 3/16" drill bit, drill the rivets securing the seat trims. Body Cover Removal 1. Remove the STORAGE COMPARTMENT COVER, see procedure in this subsection. 2. Remove the FRONT GRILLE, see procedure in this subsection. 3. Remove the plastic push-in clip securing the up- per trim. ssi2009-003-008_b LH SIDE SHOWN 1. Remove these rivets 7. Remove seat trim and drill the front rivet secur- ing the body cover. 8. At the front of front body module, remove screws or rivets retaining both body cover. 9.

Unlock rear and center retaining tabs. ssi2009-003-002_a LH SIDE SHOWN 1. Remove this plastic push-in clip 4. Move both upper trims rearward and remove them. ssi2009-003-003_a LH SIDE SHOWN 1. LH upper trim smr2009-042-058_a RH SIDE SHOWN 1. Rear retaining tabs 5. Remove the plastic push-in clips retaining the LH and RH trims. smr2009-042 479