Section 07 BODY AND HULL Subsection 02 (BODY) smr2009-042-064_a 1. Front body module retaining tabs smr2009-042-027_a 1. Central arm 2. Retaining bolts 6. Remove front body module. Front Body Module Installation The installation is the reverse of the removal pro- cedure. 5. Remove seat from vehicle. Seat Installation The installation is the reverse of the removal pro- cedure. However, pay attention to the following. Install seat to central arm. Tighten bolts to 4 N•m (35 lbf• in ). Secure lateral arms to moving deck. Install parts as shown. SEAT Seat Removal 1. Open seat. 2. Attach the seat to support it during removal. 3.
Remove Allen socket screw retaining the lateral arm to moving deck (one each side). smr2009-042-032_a 1. Allen socket screw 2. Stainless steel flat washers 3. Sleeve 4. RH lateral arm 5. Rubber grommet in moving deck smr2009-042-026_a 1. Allen socket screw 2. RH lateral arm Tighten screws to 1.5 N•m (13 lbf• in ). 4. Remove bolts securing the central arm to seat. NOTICE Do not tighten screws over this recommended torque. Otherwise, the rubber grommet could turns and screw will be hard to remove. Seat Cleaning For general purpose cleaning, use BRP PLASTIC & VINYL CLEANER (P/N 413 711 200) , Vinyl Finish Vinyl Cleaner, Fantastik or warm water with a mild dish soap such as Dawn or Ivory.
Gently scrub with a small soft bristle brush. smr2009-042 481