General Information 0A-21 Disconnecting the connector Connecting the connector Many connectors have a lock to ensure secure connections. The two types of locks generally used are those that open by lifting the release area of the lock (1), and those that open by pressing the release area (2). Before disconnecting the connector, determine in advance which type of lock the connector is using. Securely grasp the female side and male side of the connector, and align them correctly. Firmly push them together until both sides click into place. OK NO 2 1 LNW20ASH001401 Connector circuit inspection requirements LNW20ASH001201 Check the continuity of the connector using a circuit tester.
Insert the probes (1) of the tester from the harness side of the connector, as indicated in the diagram. When disconnecting the connector, first securely grasp the male side and female side of the connector. Release the lock, and carefully disconnect the connector. Do not pull the harness when disconnecting the connector, as this may cause wires to come out or break. OK OK NO 1 LNW20ASH001501 LNW20ASH001301