23 OPERATING THE VEHICLE PARKING ACCESSORY B Parking Brake Lever B 12V Electric Outlet The 12 volt receptacle is located on the front-panel. An auxiliary light or other devices may be connected to this connector. To avoid personal injury: Before dismounting vehicle A Always set parking brake and lower all implements to the ground. Leaving transmission in gear with the engine stopped will not prevent from rolling. A Stop the engine and remove the key. C This outlet is activated when the key switch is in either the "ON" or "OFF" position. When the plug is not used, pull it out. Be careful that leaving the plug inserted causes the battery to run out.
C Do not connect a light or other device that draws more than 120 watts to this connector, or the battery may discharge very rapidly or the outlet may fail. 1. Stop the vehicle on a level surface. 2. To set the parking brake, depress the brake pedal and pull the lever to park. 3. To release the parking brake, push release button and push down the parking brake lever. When the parking brake is released, the parking brake warning lamp in the Easy Checker(TM) goes off. A Do not use as a cigarette lighter. A Do not use when wet.
(1) Parking brake lever (2) Release button (A) "RELEASE" (1) 12V electric outlet A If the vehicle is operated with the parking brake applied, the parking brake will be damaged. B Utility Box (1) Utility Box