Kubota — Checking Joint Boot

51 PERIODIC SERVICE B Checking Parking Brake Pull the parking brake lever to apply the brakes. With the key switch at "ON" position, the parking brake indicator on the instrument panel lights up. To release the brakes, push in the button at the tip of the parking brake lever and tilt down the lever. B Checking Joint Boot 1. Check to see if the joint boots are not damaged. 2. If the boots are cut, cracked or shows signs of deterioration, consult your local KUBOTA Dealer. A Make sure the parking brake warning lamp on the Easy Checker(TM) goes off when parking brake lever is down.

(1) Joint boot (2) Front drive shaft (3) Tie rod (1) Parking brake lever (2) Release button (A) "PULL" (B) "RELEASE" B Checking Gauges, Meter and Easy Checker(TM) 1. Inspect the instrument panel for broken gauge(s), meter(s) and Easy Checker(TM) lamps. 2. Replace if broken. (1) Joint boot (2) Rear drive shaft (3) Grease nipple B Checking Head Light, Turn Signal Light etc. 1. Inspect the lights for broken bulbs and lenses. 2. Replace if broken. B Checking Seat Belt and ROPS 1. Always check condition of seat belt and ROPS attaching hardware before operating vehicle. 2. Replace if damaged. (1) Joint boot (2) Drive shaft