PERIODIC SERVICE 70 B Replacing Hydraulic Tank Oil Filter B Changing Front Axle Case Oil 1. Park the vehicle on a firm, flat and level surface. 2. To drain the used oil, remove the drain and filling plugs at the front axle case and drain the oil completely into the oil pan. 3. After draining, reinstall the drain plug. 4. Fill with the new oil up to the upper notch on the dipstick. (See "LUBRICANTS, FUEL AND COOLANT" in "MAINTENANCE" section.) 5. After filling, reinstall the filling plug. To avoid personal injury: A Be sure to stop the engine before changing the oil filter cartridge. A Allow engine to cool down sufficiently, oil can be hot and can burn. 1.
Park the vehicle on a firm, flat and level surface. 2. Tilt the seat. 3. Remove the oil filter. (Take care of the oil that spills from filter.) 4. Put a film of clean KUBOTA SUPER UDT OIL on the rubber seal of the new filter. 5. Quickly tighten the filter until it contacts the mounting surface, then, with a filter wrench, tighten it an additional 1 turn only. 6. After running the engine for a few minutes, stop the engine and check the oil level, add oil to the prescribed level. 7. Make sure that the hydraulic tank oil doesn't leak past the seal on the filter.
(1) Drain plug (2) Filling plug with dipstick (A) Oil level is acceptable within this range (1) Hydraulic tank oil filter (Return) A Receive the spilt oil with rags or trays. Be careful not to spill oil. If you should spill oil, wipe it off at once. A To prevent serious damage to the hydraulic line, use only a KUBOTA genuine filter. Oil capacity 0.6 L (0.6 U.S.qts.)