5 Installation | Connecting encoders DRIVE-CLiQ Pin layout of X6 Connecting the encoder cables NOTICE Damage to the product and the encoder caused by incorrect voltage supply range or incorrect wiring! An incorrect voltage supply range or incorrect wiring / pin layout may cause damage to the product and the encoder.
Note the voltage supply range of the connected encoder Verify that the connecting cable between the encoder and the product is correctly wired Vacant pins or wires must not be used Do not engage or disengage the connecting cable between the encoder and the product while under power The connection of non-HEIDENHAIN encoders to the product and the operation of the product with non-HEIDENHAIN encoders are at the user’s own risk Connect the encoder cables to the respective connections If the cable connectors include mounting screws, do not overtighten them Do not subject the plug connections to mechanical load HEIDENHAIN | PWT 100, PWT 101 | Operating Instructions | 07/2024 37 1 2 3 4 5 6 7 8 A B TXP TXN RXP / / RXN / / U P M (0 V)