8 Encoder diagnostics | Diagnosis for encoders with serial interface Display settings screen Figure 15: Display settings screen The Display settings screen enables you to change the units of the values measured by the connected encoder. The setting options vary depending on the encoder. Unit of measured position value Unit of encoder: μ m or ° (degrees) Steps [LSB] in the resolution of the connected encoder For individual encoders, for example strain sensors, the unit display is adapted, if necessary. The Steps display corresponds to the raw value that is transferred over the respective interface. Depending on the interface, a step thus has a defined resolution.
The device can perform the µm/° conversion using parameters that are stored in the encoder or by means of fixed protocol definitions. HEIDENHAIN | PWT 100, PWT 101 | Operating Instructions | 07/2024 69