heidenhain PWT 100, PWT 101 — Bar graphs for tolerance ranges

8 Encoder diagnostics | Diagnostics for encoders with 1 V PP /11 µA PP /1 V PP + Z1 interface Bar graphs for tolerance ranges The PWT display screen uses bar graphs for depiction. The following information about the encoders is shown: Sig.Amp. Signal amplitude Sig.Dev. Signal deviations RM.Pos. Reference mark position RM.ZC. Zero crossovers of reference-mark signal The display for reference mark position or reference-mark zero crossovers is based on the definition in the "Interfaces of HEIDENHAIN Encoders" brochure. Since the definition may vary depending on the specific encoder, please refer to the documentation for the encoder or the manufacturer's documentation. Display Figure 19:

Display of tolerance ranges In the bar graphs the drag indicators (black triangles) indicate the minimum and maximum value, respectively. The product uses the following colors for displaying the tolerance ranges: Color Status Description Green Pass Values are within restricted tolerance range. Especial- ly when an encoder is mounted (mounting situation), all display values should be within the green range. Yellow Adequate Tolerance range is still within the specification. This means that the encoder functions properly. Gray Not sufficient Values are outside the specifications. The encoder should no longer be operated.

A detailed analysis of the encoder with a testing device (e.g., HEIDENHAIN PWM 21) is recommended. Outside of display The values are far outside the tolerance range. A detailed analysis of the encoder with a testing device (e.g., HEIDENHAIN PWM 21) is recommended. For more information, please refer to the Product Information or the Mounting Instructions for the encoder, or the "Interfaces of HEIDENHAIN Encoders" brochure. HEIDENHAIN | PWT 100, PWT 101 | Operating Instructions | 07/2024 79