OM3212 08/11 Operator Cab and Controls - Section 32 Page 32-29 MESSAGE FOR OPERATION AND MAINTENANCE ("MOM") "MOM" (Message for Operation and Maintenance) is the message display screen located in the upper panel just above the operator’s head. It is used to display messages to the operator and service per- sonnel. The screen incorporates touch switches on its surface, to change displays. Data that "MOM" can display includes: 1. Screen i1, Initial Message Truck Condition- When the key switch is turned to the run position before cranking, the display will read OK or WAIT . If the WAIT warning is present, the reason will also dis- played.
If the engine is running and the truck is ready to be moved, the screen will indicated departure is OK or WAIT . If the WAIT warning is present, the rea- son will also be displayed. Production Data During Operation - (Information from the Payload Meter) After the key switch is turned on, the initial message (i1) is displayed for three seconds after a system message is displayed. The picture number, i1, the title, and the program version number are all indi- cated on this screen. After being displayed for three seconds, i1 is changed to the first initial check, Check 1, screen i2, automatically.
The Current Payload The Total Payload The Total Number Of Cycles Fault Information At The Time Of Occurrence The Fault Code And Its Description If any of the controllers detect a fault in their system, the i1 screen is changed to the display of the warning message i6 automatically after three seconds. The Action Code And Its Description Other Function - Clock NOTE: The operator should follow the recommendation that is displayed on the "MOM" screen. However, the operation of the truck is not prohibited. Even if the screen displays WAIT, the truck can still be operated if an emergency situation exists. 2. Screen i2, Initial Check 1