Payload Meter II - Section 60 OM6010 Page 60-4 LIGHTS, SWITCHES AND COMPONENTS On The Face Of The Payload Meter (Refer to Figure 60-1) 6. Calibration/Clear Switch 1. Display Panel Used to calibrate the machine when the condi- tions regulate this action. Also used with the TOTAL/SFT switch to clear total payload and overall number of cycles. Digital display area for the data being recorded in memory. This will include items such as: · Payload · Date & Time 7. Total/Shift Switch · Cycles Used to display payload and overall number of cycles each time the load is dumped. Will dis- play the error codes.
This switch is also used with the CALIBRATION/CLEAR switch to clear total payload and overall number of cycles. · Travel Distance · Fault Codes and Warnings 2. Reception Pilot Lamp (Rx Busy) This light will illuminate for 3 seconds when the system is powered up. It will then be lit when- ever the computer is communicating. 8. Light/Increment Switch Used to change the digital increments or units for the various displays. Also used to adjust the brightness of the lights on the monitor display. 3. Transmission Pilot Lamp (Tx Busy) This light will illuminate for 3 seconds when the system is powered up. It will then be lit when- ever the memory is being downloaded to a per- sonal computer. 9.
Memory Card Used to receive data from the payload meter memory to this card which can then be used to transfer the data into a personal computer. This enables the memory to be downloaded and saved when a personal computer is not avail- able. 4. Memory Card Access Lamp (CARD Busy) This light will illuminate for 3 seconds when the system is powered up. It will also be lit when- ever the memory data is being downloaded to the memory card. 10. Cover Protective cover for the Memory Card. Do not open or place foreign objects in slot. 5. Mode Switch This switch is used to select the mode or sys- tem that will allow a function to be performed. This may include: 11.
Diagnostic/Download Port Connector port that is used for downloading the memory data to a personal computer. · Various settings or corrections to the display · Memory card downloading · Clearing data · Display of Abnormalities or Warnings · Setting the speed limit · Setting the date and time