OM3040 03/13 Operating Instructions - Section 30 Page 30-9 MACHINE OPERATION SAFETY PRECAUTIONS 7. Apply the brake lock switch at the shovel and dump areas. After the truck engine is started and all systems are functioning properly, the operator must follow all local safety rules to insure safe machine operation. 8. Proceed slowly on rough terrain to avoid deep ruts or large obstacles. Avoid traveling close to soft edges and the edge of the fill area. 9. Truck operation requires concentrated effort by the driver. Avoid distractions of any kind while operating the truck.
If any of the red warning lights illuminate or if any gauge reads in the red area during truck opera- tion, a malfunction is indicated. Stop the truck as soon as safety permits, shut down engine if prob- lem indicates and have problem corrected before resuming truck operation. LOADING 1. Pull into the loading area with caution. Remain at a safe distance while the truck ahead is being loaded. 1. Always sound the warning horn before moving the truck. When backing the truck, give a back- up signal by honking the horn three times. When starting forward, honk the horn two times. Use these signals each time the truck is moved forward or backward. Look to the rear before backing the truck.
Watch for, and obey ground spotter's hand signals before making any reverse movements. The spotter should have a clear view of the total area at the rear of the truck. 2. Do not drive over unprotected power cables. 3. When approaching or leaving a loading area, watch for other vehicles and for personnel work- ing in the area. 4. When pulling in under a loader or shovel, follow the "spotter" or "shovel operator" signals. The truck operator may speed up loading operations by observing the location and loading cycle of the truck being loaded ahead, then following a similar pattern. 2. Operate the truck only while properly seated with the seat belt fastened.
Keep hands and feet inside the cab compartment while the truck is in operation. Keep a firm grip on the steering wheel at all times. 5. The operator should remain in the truck cab with the engine running while the truck is being loaded. Place the transmission range selector in NEUTRAL and apply the brake lock switch. 3. Check the gauges and instrument panel fre- quently during operation for proper readings. 4. Observe all regulations pertaining to the job site's traffic pattern. Be alert to any unusual traf- fic pattern. Match the truck speed to haul road conditions and slow the truck in congested areas. Obey the spotter's signals at the shovel and dump.
If the operator must leave the truck cab during loading, the engine must be shut down and the parking brake applied. DO NOT use the emer- gency brake for parking. Remain far enough away from the truck to avoid being struck by fly- ing material. 5. Do not allow the engine to run at idle for extended periods of time. 6. Check the parking brake periodically during the working shift. Use the parking brake for parking only. Do not attempt to apply the parking brake while the truck is moving! 6. When the truck is loaded, pull away from the shovel as quickly as possible, but with extreme caution.