BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Start and stop the vehicle

Start and stop the vehicle 100 Installation procedure is reverse to removal procedure. Front door opening sealing strip ban­ dage binding 2 A 1 2 A 2. Push up and remove the front roof (one piece on the left and one on the left, first remove the left roof and then the right roof). Please place the removed front roof on a softer object to prevent damage. However, it should be noted that when placing the front roof, as shown in the figure, the locating pins-A-on both sides of the roof should be aligned with the locating holes-A-on the anti-roll bars on both sides of the body. In addition, before re-tightening the bolts, make sure that the outer surface of the roof is flush with the body.

After removing the front top cover, the upper part of the door opening sealing strip is suspended in the air. It is necessary to remove the door opening sealing strip strap (with adhesive buckle) from the toolbox and fix the sealing strip -1-, -2- on the front anti- roll bar as shown in the figure. The installation position of the front roof must be correct, and the relevant accessories must be installed reliably to ensure the sealing performance and avoid water leakage, air leakage, duct leakage, and other problems caused by improper installation. WARNING