Car lights and visual field 122 Manual adjustment of headlight height Using the following road conditions as a reference, adjust the light height of the headlights by turning the rollers up and down: Position '0' Only for the driver, or the driver and pas sengers (without luggage). Position '1' All seats are full. Position '2' All seats are fully occupied, and the load of the trunk is evenly distributed (reaching the allowable axle load of the rear axle and not exceeding the maximum allowable loading mass).
Position '3' Only for the passenger seated and the luggage compartment distributes the load evenly (up to the permissible axle load of the rear axle and not exceeding the maxi mum permissible load mass). High beam delay The high beam delay function can provide you with lighting by the headlights after you leave the vehicle. Within 5 minutes after the start / stop button is in the "OFF" position, if the position light (or low beam light) is quickly turned on and off, the light delay function will start, and the headlights will automatically light up to illuminate the road ahead for you. The duration of headlight on can be set by the instrument information center.
For details, see "Information Center". Reminder that the lights are not turned off 2 3 1 2 The angle of the low beam depends on the weight distribution of passengers and luggage inside the vehicle. The height of the headlights is adjusted to ensure the view of the road surface, provide sufficient lighting for the front of the vehicle, and do not cause dizziness to other road users. As shown by the arrow in the figure, the headlight height manual adjustment roller is located in the instrument panel switch group. After turning off the one-button start switch, if the lights are not turned off, there will be a beep when the driver's door opens.