Tire 247 The pressure in a hot tire is bound to rise; if the tire pressure must be checked while the tire is hot (after the vehicle has been driven for a while), the pressure should rise by around 0.2 to 0.5 bar. In this case, do not deflate the tire to bring the tire pressure to the standard. Cold tire pressure, see Wheel Specifications on page 294 for details. When to check tire pressure How to check tire pressure Tire puncture In addition to using the tire pressure monitoring system, a high-quality pocket tire pressure gauge can also be used to check the tire pressure. It is impossible to determine whether the tire pressure is normal only by visual inspection.
The radial tire looks normal even if it is underinflated. Check the inflation pressure of the tire when it is cold. Cold state means that the vehicle stops driving for more than three hours or does not run for more than 1.6km. Remove the valve cap from the tire valve core and press the tire pressure gauge firmly on the valve to display the tire pressure. If the cold tire inflation pressure meets the recommended pressure value on the tire and loading information label, no adjustment is required. If the pressure is too low, inflate it to the recommended value; If the pressure is too high, air can be released by pressing the valve core until it meets the recommended pressure value.
After inspection, be sure to install the valve cap back on the valve core. The valve cap prevents dust and moisture from entering the inside of the tire. Your vehicle is equipped with tubeless tires. If the tires are punctured by sharp objects, the tires may not have obvious air leakage. If you find this happening, slow down immediately and drive carefully, and replace the spare tire or repair it. This type of puncture will cause the tire pressure to decrease, so it is very important to check the tire pressure regularly. Punctured or damaged tires must be repaired immediately or replaced as soon as possible. Check tires at least once a week.
Do not forget to check the spare tire pressure, which should be 220kpa. 4