BAIC BJ2021 and BJ2022 series light-weight off-road vehicles — Tire

Tire 250 When should a new tire be replaced Corrosion or dirt on wheels or wheel connectors will make wheel nuts loose after a certain period of time, which will lead to wheel falling off and traffic accidents. Therefore, when replacing the wheel, any rust or dirt at the con­ nection between the wheel and the wheel must be removed. In case of emergency, it can be removed with a cloth or paper towel, but if necessary, it is also necessary to remove all rust or dirt with a scraper or wire brush. In addition, the tightening torque of wheel nuts should be checked regularly, and the corrected torque should reach (140 ± 10) N·m.

It is recommended to check the tightening torque of each nut when the vehicle travels 1500km, 5000km, and 8000km, and tighten the wheel in strict accordance with the torque re­ quirements every time it is disassem­ bled in the future. WARNING If the tire is worn unevenly (only on one side of the tire) or excessively, go to the authorized dealer of BAIC for wheel alignment inspection. Tip If one of the following conditions occurs, the tire needs to be replaced: Tire wear indicator marks have been worn. You can directly see the cord or cord fabric in the tire rubber. The tread or sidewall is cracked, and the crack is deep enough to see the cord fabric or cord.

The tire is bulged, swelled or layered. The tire is punctured, scratched or oth­ erwise damaged, and the size and loca­ tion of the damage are difficult to repair. 4 There are wear indication marks on original tires, which are located in narrow strips in tread grooves and distributed on the circumference of tires. There are small triangles on the sidewall of the tire to indicate the position of the mark. When the tread pattern wears to the indication mark, the tire should be replaced in time.