Fuse replacement 265 Installing the knee protection cover plate Engine compartment power distribution center Check and replace the fuse. If an electrical device on the car stops working, first check whether it is caused by fuse damage. It can be determined which fuse or fuses control the component according to the diagram in the "engine compartment power distribution center layout" or the location diagram on the fuse box cover. Before you can't determine whether the damaged fuse is the cause of the fault, you can replace all the damaged fuses and check whether the electrical equipment can work normally. If there is still a fault, please contact the authorized dealer of BAIC.
Pull out the fuse that shuts down the electrical equipment and check it. Check for the blown wire in the fuse. If the fuse has blown (the fuse shown in the figure has been disconnected), replace it with a spare fuse with the same or lower ampere value. If there is no spare fuse for replacement, making the vehicle unable to move, the fuse with the same or lower ampere value can be removed from other circuits for replacement. However, it must be confirmed that you do not use this circuit temporarily, such as cigarette lighter or radio. Make sure that removing the fuse will not affect 1. Installing the knee protection cover plate 2.
Install the fixing screw on the left side of the knee protection cover plate; Tip 5 The engine compartment power distri bution center is located in front of the battery or in front of the left expansion tank.