Airbag System 026 Front row frontal airbag mainly consists of three parts: Electric control and monitoring device. Two front airbags with gas generator. Airbag failure warning light located in the information center of the combina tion instrument. The airbag is monitored by the electronic monitoring system of the airbag control unit. When the "Start/Stop button" is in the "RUN" mode, the airbag fault warning light lights up for about a few seconds and goes out after self-test. The front airbags supplement the protection offered by lap/shoulder seat belts and help protect the head and chest of the driver and front-row passenger during a severe frontal collision.
The airbag system cannot replace the seat belt, but is an integral part of the passive safety of the complete. Please note that the airbag system is best protected only when the properly worn seat belt and the properly adjusted headrest work together. Therefore, not only because of regulations, but also for safety reasons, seat belts must be worn at all times. 1 The deployment and release of the side airbag are completed in a very short time, and can not protect against the second side impact that may occur later. Attention In order to ensure that the frontal airbag can inflate and deploy normally, there must be no obstructions between the frontal airbag and the occupant.
Attention Do not place items near or above the in-dashboard airbag assembly above the steering wheel, dashboard and passenger-side glove box. Because when the vehicle has a serious colli sion enough to cause the airbag to de ploy, these objects will fly out and hurt the passengers in the vehicle. WARNING panssenger will be seriously injured when the airbag is deployed if they have not worn the seat belt or worn it improperly even if the front airbag is equipped. Therefore, panssenger must wear their seat belts.