Industrial — CODE 53 XX — OFFGOING SPEED TEST (DURING SHIFT)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 53 XX — OFFGOING SPEED TEST (DURING SHIFT) Main code 53 indicates a failed offgoing speed test. The speed test during a shift is designed to ensure neutral is attained during shifts to neutral. This test compares engine speed to turbine speed. If neutral is selected and turbine speed is found to be much lower than engine speed, the ECU sees this as neutral not being attained. The transmission is commanded to Neutral with No Clutches and code 53 XX is set. Additional codes could be logged for other shifts where “X” indicates the range from and “Y” indicates the range to. NOTE:

This test is not performed if neutral output is below 200 rpm or when temperatures are below a calibrated 0˚C (32˚F). A. Active Indicator Clearing Procedure: Power down Manual — subcodes 19, 78, and 99 only NOTE: Before troubleshooting, read Paragraph 6–6. Also, check battery and ECU input voltages. NOTE: Intermittent connections or lack of battery-direct power and ground connections may cause this and other codes. B. Troubleshooting: NOTE: When a shift completes before the offgoing ratio test completes, an incorrect code 53 12 may be set instead of 51 12. This should be corrected in software versions 9B and later. 1. Be sure the transmission is warm and the fluid level is correct.

Correct transmission fluid level as necessary. 6–78 Copyright © 2001 General Motors Corp. Main Code Subcode Meaning 53 08 L–N1 shift 53 09 L–NNC shift 53 18 1–N1 shift 53 19 1–RELS shift 53 28 2–N1 shift 53 29 2–N2 shift 53 38 3–N1 shift 53 39 3–N3 shift 53 48 4–N1 shift 53 49 4–N3 shift 53 58 5–N1 shift 53 59 5–N3 shift 53 68 6–N1 shift 53 69 6–N4 shift 53 78 R–N1 shift 53 99 N3–N2 or N2–N3 shift 53 XY X–Y shift