WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 54 XX — ONCOMING SPEED TEST (AFTER SHIFT) Main code 54 indicates a failed oncoming ratio test. The ratio test after a shift is failed when the ECU has commanded the end of a shift and has not seen the transmission shift into the target range (comparing turbine and output speeds). Erratic readings from speed sensors are a likely cause of an oncoming ratio test failure. If conditions for a shift still exist, the shift will be retried one more time. If the ratio test is still not met, a code is logged and the DO NOT SHIFT response is commanded.
If the code is set during a direction change, Neutral with No Clutches is commanded, otherwise the transmission is commanded to the previous range. Code 54 12 can also be caused by the ECU being calibrated for a close ratio transmission and installed with a wide ratio transmission, or vice versa. Additional codes could be logged for other shifts where “X” indicates the range from and “Y” indicates the range to. NOTE: This test is not performed below a calibrated transmission output speed of 200 rpm. 6–80 Copyright © 2001 General Motors Corp. Main Code Subcode Meaning 54 01 L–1 upshift 54 07 L–R shift 54 10 1–L downshift 54 12 1–2 upshift — may be incorrect calibration (wide ratio vs.
close ratio or close ratio MD instead of HD) 54 17 1–R shift 54 21 2–1 downshift 54 23 2–3 upshift 54 24 2–4 upshift 54 27 2–R shift 54 32 3–2 downshift 54 34 3–4 upshift 54 35 3–5 upshift 54 42 4–2 downshift 54 43 4–3 downshift 54 45 4–5 upshift 54 46 4–6 downshift 54 53 5–3 downshift 54 54 5–4 downshift 54 56 5–6 upshift 54 64 6–4 downshift 54 65 6–5 downshift 54 70 R–L shift 54 71 R–1 shift 54 72 R–2 shift 54 80 N1–L shift 54 81 N1–1 shift 54 82 N1–2 shift 54 83 N1–3 shift 54 85 N1–5 shift 54 86 N1–6 shift 54 87 N1–R shift — associated with loose output speed tone wheel on MD, B 300, and B 400 models 54 92 N2–2 shift 54 93 N3–3 shift 54 95 N3–5 shift 54 96 N4–6 shift 54 XY X to Y shift