WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 56 XX — RANGE VERIFICATION RATIO TEST (BETWEEN SHIFTS) Main code 56 indicates a failed range verification speed sensor ratio test. The ratio test occurs after a shift and determines if a clutch has lost torque carrying capability. If output speed is above programmed output speed for a range but the correct speed sensor ratio is not present, the DO NOT SHIFT response is commanded and a range which can carry the torque without damage is commanded or attempted. Turbine and output speed sensor readings are used to calculate the actual ratio that is compared to the commanded ratio.
Main code 56 can also be caused by the ECU being calibrated for a close ratio transmission and installed with a wide ratio transmission, or vice versa. A. Active Indicator Clearing Procedure: Power down Manual — subcodes 11, 44, 66, and 77 only NOTE: When a code 22 16 (output speed fault) is also present, follow the troubleshooting sequence for code 22 16 first. After completing the 22 16 sequence, drive the vehicle to see if a code 56 XX recurs. NOTE: Before troubleshooting, read Paragraph 6–6. Also, check battery and ECU input voltages. NOTE: Intermittent connections or lack of battery-direct power and ground connections may cause this and other codes. B. Troubleshooting: 1.
After the transmission is at operating temperature, allow vehicle engine to idle on level ground for 3–4 minutes. Check the transmission fluid level. If improper fluid level is found, correct as necessary. Improper fluid level could be the cause of the code. Not enough or too much fluid may produce inadequate clutch pressure. 2. Connect a pressure gauge and check main pressure. If the pressure is not adequate, the pump is probably worn. See Appendix B for main pressure specifications. 3. If main pressure is adequate, check clutch pressure for the range indicated by following the procedure in Appendix B.
The transmission range indicated by the trouble code can be found by referring to the solenoid and clutch chart in Appendix C. Drive the vehicle or use the diagnostic tool’s clutch test mode and check clutch pressure. 4. If a clutch is leaking pressure, drain the fluid, remove the control module and check for damaged control module gaskets and stuck or sticking valves (see the transmission Service Manual). Also look for damaged or missing face seals. If no problems are found, replace the solenoids for the clutches used in the range indicated by the code. Copyright © 2001 General Motors Corp.
6–85 Main Code Subcode Meaning 56 00 Range verification ratio test (between shifts) L 56 11 Range verification ratio test (between shifts) 1 56 22 Range verification ratio test (between shifts) 2 56 33 Range verification ratio test (between shifts) 3 56 44 Range verification ratio test (between shifts) 4 56 55 Range verification ratio test (between shifts) 5 56 66 Range verification ratio test (between shifts) 6 56 77 Range verification ratio test (between shifts) R