WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 63 XX — INPUT FUNCTION FAULT 4. Code 63 41 Use the DDR to identify the two wires associated with the input functions for Pump/Pack Enable and Automatic Neutral For Refuse Packer. Inspect the input wiring, connectors, and switches to determine why the input states are different. Correct problems which are found. There is further information on these input functions on pages P–32, P–33, and P–38 through P–41. 5. Code 63 47 Check the RELS input wire (number 178V28) for short-to-ground that would provide a false signal of RELS operation. Also, check the brake pressure switch which may be stuck in the “ON” (closed) position.
This code sets when a calibration number of throttle increases above a calibration percent throttle opening occur when the RELS signal is active. 6–94 Copyright © 2001 General Motors Corp.