Industrial — 7–2. OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL INPUT AND OUTPUT FUNCTIONS 7–2. OUTPUT FUNCTIONS Output functions are signals sent out by the ECU that activate or control devices or mechanisms. These control devices or mechanisms are controlled by relays or direct connection signals from the ECU. Many input and output functions are closely related. For instance, the PTO Enable option (input function) also includes PTO Output wiring information. When searching for output function information, be sure to check any related input function information references.

The wiring schematics in Appendix J and Appendix P illustrate installation requirements for output functions as well as input functions and designate specific wire numbers in the transmission control system to be used for the activation of these output functions. The wiring schematics in Appendix J should be used for reference only. Ask the vehicle manufacturer which specific output functions are programmed and which wires are used. Output function polarity is not significant when an Allison-supplied VIM is used. The ATDT TM or Pro-Link ® 9000 can also be utilized to determine which wire was programmed for a particular output function.

For more detailed information on output functions, refer to the Sales Tech Data Book “WTEC III Controls and General Information” (the schematics in Appendix P are from the Sales Tech Data Book). Copyright © 2001 General Motors Corp.