Industrial — Table 8–1. Troubleshooting Performance Complaints

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL GENERAL TROUBLESHOOTING OF PERFORMANCE COMPLAINTS Copyright © 2001 General Motors Corp. Table 8–1.

Troubleshooting Performance Complaints Problem Probable Cause Suggested Remedy SHIFT SELECTOR DISPLAYS “CATEYE” AND VEHICLE IS NOT OPERABLE No communication between the ECU and a remote shift selector Refer to code 23 XX in Troubleshooting Procedure SHIFT SELECTOR DISPLAY IS BLANK VIM Fuse is blown Replace VIM fuse Fuse blown in OEM substitute Replace fuse for VIM Failed SDL (Serial Data Link) Should change to “cateye” within 12 seconds (see Code 23 16) SHIFT SELECTOR NOT LIGHTED AT NIGHT (WHEN HEADLIGHTS ARE ON) Wires 186, 187, or 188 are not connected or are improperly connected. Find wires 186, 187, and 188 and connect them or install wires, if necessary.

VEHICLE WILL NOT START (ENGINE WILL NOT CRANK) Lever shift selector not in neutral Select N (Neutral) and restart Dead battery Recharge battery Disconnected battery Reconnect battery Faulty starter circuit Repair vehicle starter circuit Faulty neutral start relay Replace neutral start relay Faulty wiring in neutral start circuit Repair wiring Voltage to ECU too low Check battery and charging system voltage Faulty ignition wire (146) Repair wire 146 Faulty lever shift selector Replace lever shift selector Lack of battery voltage on Circuit 123 from ECU when in neutral Repair Circuit 123 or replace ECU All display segments of display lighted No calibration installed in ECU Voltage to ECU too low Load Calibration Check battery and charging system voltage CHECK TRANS LIGHT WILL NOT GO OUT AT START-UP A.

Vehicle Drives Normally Faulty CHECK TRANS light, relay, or circuit. Replace relay or repair circuit An LED rather than a lamp is installed for the CHECK TRANS light and the LED is partially lighted from leakage current Install a lamp rather than an LED for the CHECK TRANS light