Industrial — APPENDIX B — CHECKING CLUTCH AND RETARDER PRESSURES

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX B — CHECKING CLUTCH AND RETARDER PRESSURES Copyright © 2001 General Motors Corp. Checking individual clutch pressures helps to determine if a transmission malfunction is due to a mechanical or an electrical problem. Properly making these pressure checks requires transmission and vehicle (or test stand) preparation, recording of data, and comparing recorded data against specifications provided. These instructions are for all WT Series transmissions. NOTE: Check to see if there are diagnostic codes set which are related to the transmission difficulty you are evaluating.

Proceed to make mechanical preparations for checking clutch pressures after codes have first been evaluated. A. Transmission and Vehicle Preparation 1. Remove the plugs from the pressure tap locations where measurement is desired (refer to Figure B–1). MD/B 300/B 400 MD 3070PT TRANSFER CASE HD/B 500 C3 C6 (MD 3070PT ONLY) C5 C3 C5 MAIN C7 MAIN MAIN C2 LU C2 LU C4 T-CASE C6 PRESSURE TAP C4 CONNECTOR C1 (On left side of C1 adapter housing, near the bottom) HD 4070 FRONT VIEW NOTE: Retarder charging pressure tap is located on the retarder control valve body for all models with retarder. V05929 Figure B–1. Clutch Pressure Check Points CAUTION:

Be sure that the hydraulic fittings have the same thread as the plugs removed (7/16-20 UNF-2A). Also please note that these fittings must be straight thread, O-ring style. Failure to do this will result in damage to the control module. 2. Install hydraulic fittings suitable for attaching pressure gauges or transducers. 3. Connect pressure gauges or transducers. Pressure gauge set J 26417-A is available for this purpose. See Table B–2 for pressure levels expected. 4. Check that engine speed can be monitored (ATDT™ or Pro-Link® 9000 diagnostic tool may be used for this purpose).