WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–4. DELPHI-PACKARD METRI-PACK 150 SERIES CONNECTORS — PUSH-TO-SEAT (MD/HD/B TID 2 SUMP TEMPERATURE THERMISTOR) A. Connector/Terminal Repairs: Crimping Tool J 42215 (with terminal positioner removed) Remover Tool J 35689-A Use Description Manufacturers P/N MD/HD/B, TransID 2 Sump Temperature Sensor 12129691 Sump Temperature Thermistor Connector, Black 12047662 Terminal 12047767 Secondary Lock 12047664 B. Terminal Removal: 1. Remove the secondary lock from the connector. 2.
Insert needle end of terminal remover J 35689-A into the small notch in the front of the connector cavity of the terminal to be removed (refer to Figure E–4). 3. Push the lock tang toward the terminal. 4. Pull the wire and terminal out of the connector. 5. Cut the terminal between the core and insulation crimp to minimize wire loss. C. Terminal Crimping: 1. Strip insulation approximately 4.5 mm (0.18 inch). 2. Remove the spring-loaded terminal positioner from the J 42215 crimping tool. 3. Insert the new terminal to be crimped in the J 42215 crimping tool. Squeeze the crimper handles a couple clicks to start the crimping process but leave room to insert the wire end. 4.
Insert the bare wire end into the terminal. Squeeze the crimper handles to complete the crimping process and until the crimper handles open when released to remove the terminal/wire from the tool. 5. Be sure the lock tang is positioned to allow proper retention of the terminal in the connector. 6. Push the terminal completely into the cavity. (A click will be heard and the terminal should stay in place if the wire is pulled.) 7. Install the secondary lock in the connector. Copyright © 2001 General Motors Corp. E–17