Industrial — 1–6. DELPHI-PACKARD METRI-PACK 280 SERIES CONNECTORS — PUSH- TO-SEAT (DDR, SCI)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–6. DELPHI-PACKARD METRI-PACK 280 SERIES CONNECTORS — PUSH- TO-SEAT (DDR, SCI) A. Connector/Terminal Repairs Crimping Tool J 38125-6 and 7 Wire Crimp Anvil “2” Insulation Crimp Anvil “A” Remover Tool J 38125-13 Use Description Manufacturers P/N Diagnostic Connector Connector 12048105 Terminal 12034046 Terminal (2-Wire) 12066214 Secondary Lock 12020219 Cover 12048107 SCI Connector Connector 15300002 Terminal, Socket 12077411 Seal, Wire 12089444 Secondary Lock 15300014 B. Terminal Removal 1.

Remove secondary lock from back of connector (Figure E–6, View C). (Use a small screwdriver or pick in the slots on each side of the connector.) 2. Insert remover tool J 38125-13 into open (front) end of connector at terminal to be serviced (Figure E–6, View A). 3. Push the lock tang of the terminal straight and pull wire and terminal out the back of connector. 4. If the terminal is to be replaced, cut terminal between core and insulation crimp (this minimizes wire length loss). C. Terminal Crimping 1. Carefully strip insulation 6.0 ± 0.25 mm (0.24 ± 0.01 inch). 2. Insert terminal into crimping tool (Figure E–6, View D), anvil “2.” 3. Slightly close crimping tool to hold the terminal steady.

4. Align the terminal with its position in the connector and insert wire so that the stripped portion of the wire is in the core crimping area and the insulated portion of the wire is in the insulation crimping area (Figure E–6, View B). 5. Crimp the stripped section of the wire (Figure E–6, View D). 6. Remove the terminal from the crimping tool. 7. Use a pair of needle nose pliers, if necessary, to start the bend on the insulation crimp wings (Figure E–6, View D). 8. Crimp the insulated section of wire using anvil “A” of the crimpers shown (Figure E–6, View D). 9. Remove the terminal from the crimping tool. 10. Tug on terminal to make sure the crimp is tight.

Copyright © 2001 General Motors Corp. E–21