WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–7. DELPHI-PACKARD WEATHERPACK CONNECTORS (TPS; 3-WAY RMR SENSOR; HD RETARDER TEMPERATURE; 3-WAY RMR DEVICE (DEDICATED PEDAL)) A.
Connector/Terminal Repairs Crimping Tool J 38125-6 Wire Crimp Anvil “2” Insulation Crimp Anvil “5” Alternate Crimping Tool J 35606 or J 38852 Remover Tool J 38125-10 Use Description Manufacturers P/N Throttle Position (TPS) Connector Terminal Wire Seal 12015793 12089040 12089444 RMR Device Connector Terminal Wire Seal 12015795 12089040 12089444 Retarder Temperature Sensor Connector Terminal (Socket) Wire Seal 12010973 12089188 12089444 B. Terminal Removal 1. Unlatch and open the secondary lock on the connector (Figure E–7, View A). 2. On the front of the connector, insert remover tool J 38125-10 over the terminal.
Push the tool over the terminal and pull the terminal out of the back end of the connector (Figure E–7, View B). 3. If terminal is to be replaced, cut terminal between core and insulation crimp (this minimizes wire loss). NOTE: Two special tools are available for this operation: tool J 38125-6 (Paragraph C); tool J 35606 or J 38852 (Paragraph D). C. Terminal Crimping Using Crimping Tool J 38125-6 1. Place the wire seal onto the wire before stripping the wire (Figure E–7, View C). 2. Strip wire to 6.0 ± 0.25 mm (0.24 ± 0.01 inch). 3. Place terminal onto crimping tool J 38125-6 (Figure E–7, View E), anvil “2.” 4. Slightly close crimping tool to hold terminal steady. 5.
Insert wire so that the stripped portion of wire is in the core crimp area and the insulated portion of the wire is in the insulation crimping area (Figure E–7, View C). 6. Crimp the stripped section of the wire. 7. Remove the terminal from the crimping tool. Copyright © 2001 General Motors Corp. E–25