Industrial — 1–10. ITT CANNON CONNECTORS — CRIMPED (37-WAY FMTV BULKHEAD; 6-WAY TRANSFER CASE; 8-WAY MD RETARDER)

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS 1–10. ITT CANNON CONNECTORS — CRIMPED (37-WAY FMTV BULKHEAD; 6-WAY TRANSFER CASE; 8-WAY MD RETARDER) A.

Connector/Terminal Repair Crimping Tool Connector Repair Kit (FMTV) Guide Pin Insertion Tool Terminal Remover Terminal Remover/Installer (MD Retarder) Terminal Remover/Installer (MD 3070 T-Case Connector) J 34182 J 41193 J 41193-1 J 41193-2 J 41193-3 J 39841 J 39842 Use Description Manufacturers P/N MD FMTV 37-Way Plug Assembly 37-Way Receptacle Assembly CA3106E28-21P-B CA3100E28-21S-B MD Transfer Case 6-Way Plug Assembly Terminal (Socket) Cavity Plug KPSE06E10-6S 031-9174-004 225-0070-000 6-Way Receptacle Assembly Terminal (Pin) Cavity Plug KPSE07E10-6P 030-9173-006 225-0070-000 MD Retarder 8-Way Plug Terminal, Socket Cavity Plug KPSE06E16-8S 031-9206-006 225-0071-000 8-Way Receptacle Terminal (Pin) Cavity Plug KPSE07E16-8P 030-9205-007 225-0071-000 B.

Terminal Removal (Refer to Figure E–11, View A and B) 1. Select the remover tool for the plug or receptacle that is being repaired. 2. For the FMTV connector, choose either the pin or socket terminal remover tip and lock it into the handle. 3. Place the tip of the remover tool over the pin or into the socket and push the contact/terminal out the rear of the connector using slow, even pressure. 4. Pull the wire and terminal out the back of the connector. 5. If replacing the terminal, cut the wire through the middle of the terminal crimp to minimize wire loss. Copyright © 2001 General Motors Corp. E–35