Industrial — APPENDIX F — THROTTLE POSITION SENSOR ADJUSTMENT

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX F — THROTTLE POSITION SENSOR ADJUSTMENT A. Description of Operation (Figure F–1) 1. To properly communicate throttle position to the Electronic Control Unit (ECU), the throttle posi- tion sensor must convert its mechanical movement to an electrical form the ECU can understand. To accomplish this, contacts move across a resistive strip inside the sensor which translates posi- tion into voltage. THROTTLE POSITION LINKAGE CONTACTS RESISTIVE STRIP V00656.01 Figure F–1. Throttle Position to Voltage Conversion 2. Each position gives a different voltage. The ECU then converts the voltage to counts.

Each count corresponds to approximately 0.179 mm (0.007 inch) of throttle sensor movement. Figure F–2 diagrams the counts and throttle movement relationship. Adjust so total stroke is within 50–200 count band 0 COUNT 255 COUNTS 14 COUNTS 233 COUNTS ERROR ZONE ERROR ZONE 50 COUNTS APPROX. 19 mm (0.75 in.) STROKE 200 COUNTS CLOSED THROTTLE WIDE OPEN THROTTLE FULLY RETRACTED (AT REST) Total Stroke CT–WOT 15.2 mm–22.9 mm (0.6 in.–0.9 in.) 85–130 Counts FULLY EXTENDED 2.5 mm (0.1 in.) 40.6 mm (1.6 in.) 0 mm 45.7 mm (1.8 in.) V00429.05 Figure F–2. Throttle Position Determination Diagram 3.

Throttle percentage is proportional to counts; low counts correspond to low percent and high counts correspond to high percent (Table F–1, Page F–3). 4. The conversion from counts to percent throttle is performed easily once the idle and full throttle positions are set (see adjustment procedures below). The idle and full throttle positions correspond Copyright © 2001 General Motors Corp.