Industrial — 1–2. GENERAL GUIDELINES FOR RADIO EQUIPMENT INSTALLATION

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL APPENDIX L — EXTERNALLY-GENERATED ELECTRONIC INTERFERENCE 1–1. ELECTROMAGNETIC/RADIO FREQUENCY INTERFERENCE Be sure that the ECU for the Allison Transmission Electronic Controls is properly grounded to prevent EMI interference problems. The chassis frame must be connected to the negative post of the vehicle battery. A proper connection to the chassis frame is required. The connection must be free from rust and paint. The electrical integrity of this connection must not deteriorate with the age of the vehicle.

If the ECU is cab-mounted, there must be two 1 1 2 to 2 inch braided grounding straps connecting the cab structure to the chassis frame. DO NOT connect wire 144-V25 to a bus bar or to any single terminal carrying other electrical loads. All electrical and electronic systems generate electromagnetic fields that can interfere with other electronic systems. Allison Transmission electronic transmission controls comply with Federal Communications Commission (FCC) regulations and other guidelines concerning emitted radio frequency interference for transportation electronics.

The position of Allison Transmission Division of General Motors is that manufacturers and installers of EMI/RFI emitting equipment are responsible for adhering to FCC regulations and other guidelines concerning emitted radio frequency interference for transportation electronics. Some radio-telephone or two-way communication radios (land-mobile radio), or the manner in which they are installed, can adversely affect vehicle operation or be affected by other vehicle components.

Expenses incurred to protect vehicle-related systems from EMI/RFI emissions by radio-telephone or two-way communications radios (land-mobile radio) or to integrate such devices into vehicles are not the responsibility of Allison Transmission. 1–2. GENERAL GUIDELINES FOR RADIO EQUIPMENT INSTALLATION The following general guidelines for installing radio-telephone or two-way communications radios (land-mobile radio) in a vehicle supplement, but DO NOT replace, detailed instructions provided by the radio equipment manufacturer. Detailed installation instructions are the sole responsibility of the radio equipment manufacturer.

Experience has shown that most EMI/RFI problems can be prevented or eliminated by following the guidelines. If EMI/RFI problems persist after following the guidelines and after ensuring the installation conforms to the guidelines, contact the vehicle and radio equipment manufacturers for additional installation or equipment operation instructions. A. Transmitter Installation 1. Locate remote radio transmitters as far away from other electronic devices and as near to the side of the vehicle body as possible. 2. Mount transceivers (transmitter and receiver in one box) under the dash so as not to interfere with vehicle controls or passenger movement. B.

Antenna Installation Each vehicle and body style react differently to radio frequency energy. When dealing with an unfamiliar vehicle, test various antenna locations by using a magnetic mount antenna and checking for adverse effects. Antenna location is a major factor in EMI/RFI problems. C. Antenna Cable Routing 1. Use high quality, 95 percent shield coverage, coaxial (coax) cable. Route the coax well away from any electronic components. 2. Route antenna cables as far away from vehicle wiring as possible to reduce the likelihood of the vehicle wiring acting as an antenna for interference. Copyright © 2001 General Motors Corp.