Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL I. EUROPEAN ENGINE BRAKE ENABLE AND PRESELECT REQUEST PLUS ENGINE BRAKE ENABLE OUTPUT WITH SINGLE LEVEL COMPRESSION BRAKES USES: Used with engine brakes to provide a signal to the ECU that the brake is active and to provide increased braking by preselecting a lower range. Also prevents engagement of engine brake with throttle > 0 or lockup off. VARIABLES TO SPECIFY: Preselect range. Standard value is fourth range. VOCATIONS:

Various * ENGINE THROTTLE SWITCH SWITCHED POWER NC V V-3 WIRE 132 ENGINE BRAKE ENABLE OUPUT E2 COM ENGINE BRAKE NO E3 DASH LIGHT (OPTIONAL) BRAKE ON ** OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) ECU Relay shown de-energized VIM S-26 WIRE 169 ENGINE BRAKE AND PRESELECT REQUEST * NOTE: This switch is part of the engine brake system and provides an indication when the engine is at closed throttle. This switch, or an equivalent control feature, is RECOMMENDED for all installations. S S-32 ENGINE BRAKE DASH SWITCH WIRE 143H SIGNAL RETURN ** NOTE: If the engine brake solenoid is an inductive load, it must be diode suppressed. V07135 Figure P–15.

European Engine Brake Enable and Preselect Request Plus Engine Brake Enable Output With Single Level Compression Brakes Copyright © 2001 General Motors Corp. P–15 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. B1