Industrial — APPENDIX P — INPUT/OUTPUT FUNCTIONS

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL J. FIRE TRUCK PUMP MODE — OPERATOR ONLY ACTIVATED USES: Facilitates engagement of split shaft PTO and shifts transmission to fourth range lockup. VARIABLES TO SPECIFY: None VOCATIONS: Fire Truck Pumpers SYSTEM OPERATION OPERATOR ACTION — System Response TO ENGAGE: 1. SELECT NEUTRAL — Transmission shifts to Neutral. 2. APPLY PARK BRAKE — None 3. SELECT PUMP — Turns on “Pump Mode Requested” light. Turns on both input signals to ECU (wires 117 and 118) which activates “fire truck” mode. When split-shaft shifts, “Pump Engaged” light is turned on. 4. SELECT DRIVE — Transmission shifts to fourth lockup. “OK To Pump” light is turned on.

TO DISENGAGE: 1. SELECT NEUTRAL — Transmission shifts to Neutral if output shaft speed is less than 1000 rpm. 2. SELECT ROAD MODE — PTO disengages. If output shaft rotation continues, press the Momentary Trans. Brake Switch before selecting road mode. This will cause the transmission output shaft to stop if transmission is in Neutral and output shaft speed is less than 100 rpm (175 rpm beginning with V9A calibrations). OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) SWITCHED POWER DASH SWITCH Open: Road Closed: Pump WIRE 117 PUMP ENABLE POSITIVE PUMP ENGAGEMENT (PPE) SWITCH Switch is closed when pump is engaged V V-31 V-30 WIRE 161 SIGNAL RETURN V-13 V-2 MOMENTARY TRANS.

BRAKE SWITCH ECU PARKING BRAKE PRESSURE SWITCH Switch is closed when brakes are on SPLIT- SHAFT PTO WIRE 118 FIRE TRUCK PUMP MODE INPUT A2 A3 S PUMP MODE REQUESTED F3 VIM Relay shown de-energized WIRE 114 RANGE INDICATOR = 4th V04870 Figure P–17. Fire Truck Pump Mode — Operator Only Activated Copyright © 2001 General Motors Corp. P–17 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life.

ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! If this function is enabled in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be disabled in the calibration. OK PU TO MP NC COM NO PU ENG MP AGED