WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL X. SHIFT IN PROCESS/SHIFT ENABLE USES: Used to reduce engine power during a shift for high horsepower applications. VARIABLES TO SPECIFY: None VOCATIONS: Oil field pumping OPERATING PROCEDURE 1. ECU sends signal (“Shift in Process”) to powertrain module that a shift is being requested. 2. Powertrain module reduces engine power and sends a signal to ECU (“Shift Enable”) indicating that it is OK to shift. 3. ECU commands shift. When shift is completed, “Shift in Process” output turns off. 4. Powertrain module turns off the Shift Enable signal. OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) NOTE:
This function must NOT be used when the transmission is used for vehicle propulsion. WIRE 117 SHIFT ENABLE V V-30 V-18 POWERTRAIN CONTROL MODULE ENGINE FUEL CONTROL ECU NC D1 TYPICAL SHIFT S WIRE 125 SHIFT IN PROCESS COM NO OFF ON SHIFT ENABLE VIM SHIFT IN PROCESS OFF ON Relay shown de-energized V04877 Figure P–26. Shift in Process/Shift Enable P–26 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown.
Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! If this function is enabled in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be disabled in the calibration. E1