WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL AJ. FOURTH LOCKUP PUMP MODE — OPERATOR AND PUMP ACTIVATED USES: Facilitates engagement of split shaft PTO and shifts transmission to fourth range lockup for driving a vehicle-mounted pump. VARIABLES TO SPECIFY: None VOCATIONS: Street cleaners, sewer cleaners SYSTEM OPERATION OPERATOR ACTION — System Response TO ENGAGE: 1. SELECT NEUTRAL — Transmission shifts to Neutral. 2. APPLY PARKING BRAKE — None 3. SELECT PUMP — Turns on “Pump Mode Requested” light. Turns on input signal to ECU (wire 118) which activates “fire truck” mode. When split-shaft shifts, wire 117 is activated and “Pump Engaged” light is turned on. 4.
SELECT DRIVE — Transmission shifts to fourth lockup. “OK To Pump” light is turned on. TO DISENGAGE: 1. SELECT NEUTRAL — Transmission shifts to Neutral if output rpm is less than 1000. 2. SELECT ROAD MODE — PTO disengages. If output shaft rotation continues, press the “Momentary Trans. Brake” switch before selecting Road Mode. This will cause the transmission output shaft to stop if transmission is in Neutral and output shaft speed is less than 100 rpm (175 rpm beginning with V9A calibrations). WIRE 118 4th LOCKUP PUMP MODE INPUT MOMENTARY TRANSMISSION BRAKE SWITCH PARKING BRAKE PRESSURE SWITCH Switch is closed when brakes are on DASH SWITCH Open: Road Closed:
Pump SWITCHED POWER WIRE 161 SIGNAL RETURN AIR Switch is closed when pump is engaged Relay shown de-energized PUMP MODE REQUESTED VIM NC A2 A3 ECU S OPTIONAL CUSTOMER- FURNISHED VIW CONNECTOR(S) WIRE 117 PUMP ENABLE F3 PUMP ENGAGED OK TO PUMP SWITCHED POWER WIRE 114 RANGE INDICATOR (4th) V07126 Figure P–35. Fourth Lockup Pump Mode — Operator and Pump Activated P–36 Copyright © 2001 General Motors Corp. APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown.
Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. WARNING! If this function is turned “ON” in the shift calibration, the function MUST be integrated into the vehicle wiring. If the function is available in the shift calibration but will not be used in the vehicle, it MUST be turned “OFF” in the calibration. V V-13 V-31 V-30 V-2 SPLIT- SHAFT PTO COM NO