WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL AQ. SELECTOR DISPLAY BLANKING USES: Blanks the digital display and mode on indicator on the lever or pushbutton shift selectors. VARIABLES TO SPECIFY: None VOCATIONS: Military wheeled vehicles SWITCHED POWER V-28 WIRE 178 SELECTOR DISPLAY BLANKING V DASH SWITCH Open: NORMAL Closed: BLANK OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) ECU Display and indicator are blanked when switch is closed SELECT S R MODE For Shift Selector wiring requirements, see installation drawing AS07-27 (see SA2978 WTEC III Controls and General Information) N D V04891.01 Figure P–46. Selector Display Blanking Copyright © 2001 General Motors Corp.
P–47 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING! These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES.