WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL I. ENGINE OVERSPEED INDICATOR USING VIM USES: To turn on dash light when engine reaches an overspeed condition. VARIABLES TO SPECIFY: Rpm to turn ON; rpm to turn OFF. VOCATIONS: Various OPTIONAL CUSTOMER-FURNISHED VIW CONNECTOR(S) SWITCHED POWER Contacts close when engine speed exceeds a calibration value. V Contacts open when engine speed falls below a lower calibration value. V-22 NC ECU F2 COM NO F3 D2 WIRE 112 ENGINE OVERSPEED INDICATOR GROUND S Relay shown de-energized VIM V07175 Figure P–53. Engine Overspeed Indicator Using VIM Copyright © 2001 General Motors Corp. P–57 APPENDIX P — INPUT/OUTPUT FUNCTIONS WARNING!
These schematics show the intended use of the specified controls features which have been validated in the configuration shown. Any miswiring or use of these features which differs from that shown could result in damage to equipment or property, personal injury, or loss of life. ALLISON TRANSMISSION IS NOT LIABLE FOR THE CONSEQUENCES ASSOCIATED WITH MISWIRING OR UNINTENDED USE OF THESE FEATURES. ENG OVERS INE PEED