Industrial — 6–5. DIAGNOSTIC CODE LIST AND DESCRIPTION

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL DIAGNOSTIC CODES Table 6–2. WT Series Diagnostic Codes (cont’d) CHECK TRANS Light Inhibited Operation Description Main Code Sub- code Description 69 (cont’d) 29 ECU, inoperative N and H-Hi switch No Low and first inhibited, retarder inhibited, DNA 33 ECU, Computer Operating Properly (COP) timeout No Reset ECU, shutdown ECU on 2nd occurrence (power loss; hydraulic defaults).

May cause “cateye” display or all segments blank display, DNA (4) 34 ECU, write timeout Yes DNS, SOL OFF (hydraulic default), DNA 35 ECU, checksum test No Induce COP timeout (reset ECU), DNA (4) 36 ECU, RAM self test No Induce COP timeout (reset ECU), DNA (4) 39 Communication chip addressing error No Use defaults for J1939 data, DNA 41 ECU, I/O ASIC addressing test No Induce COP timeout (reset ECU), DNA (4) 42 SPI output failure Yes GPO 1–8 and reverse warning inoperable 43 SPI input failure Yes DNS, lock-in-range, DNA 70 12 Software, minor loop overrun No Induce COP timeout (reset ECU) 13 Illegal write to address $0000 No Induce COP timeout (reset ECU) 14 Software, major loop overrun No Induce COP timeout (reset ECU) NOTES (1) This code is logged to real time to protect the transmission in case a loss of power to the ECU (Power Inter- ruption, code 35 00) occurs.

(2) The ECU hardware or software must be changed so that they are compatible. (3) Additional codes could be logged for other shifts where X indicates range shifted from and Y indicates range shifted to. (4) The COP reset will clear the active inhibit. (5) The factory calibration must be rewritten to the ECU, or a different factory calibration is required to match the software in the ECU. (6) Do not adapt torque managed shifts when this code is active. Copyright © 2001 General Motors Corp. 6–13