WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 21 XX — THROTTLE OR PWM FAULT (Figure 6–4) DIAGNOSTIC CODES 6–30 Copyright © 2001 General Motors Corp. 3. If the throttle counts do not change or are erratic, check the throttle sensor wiring for opens, shorts between wires, or shorts-to-ground. Also check for correct TPS voltages using test wiring harness J 41339. If wiring problems are found, isolate and repair the fault (refer to Appendix E for repair information). 4. If the wiring is satisfactory, replace the throttle position sensor and adjust its linkage so the counts are not in the error zones (see Appendix F). 5.
If the throttle sensor and its linkage adjustment are correct and the wiring to the sensor is satisfac- tory, the condition is intermittent. Replace the sensor and properly adjust the new sensor. 6. If the condition recurs, use a spare wire, if available, or provide a new wire (St. Clair P/N 200153 may be used for this purpose) for the throttle sensor circuit. See Appendix E for connector repair information. CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage. Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle.
This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle. Transmission performance could be worse and damage to the clutches may occur. NOTE: If using an ECU from another vehicle is unavoidable, the ECU must be set to unadapted shifts and the vehicle must be driven carefully to adapt the shifts to the test vehicle. Refer to Service Information Letter 16-WT-96 for the correct procedure. Be sure to reset the ECU to unadapted shifts when it is returned to the original vehicle. 7.
If the condition persists, replace the ECU with a test diagnostic ECU (P/N must match and it is recommended that the controller be loaded with the latest version of the CIN). If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU. If the original ECU now works, inspect the ECU connectors for corrosion or damage which may cause an intermittent condition. If the original problem recurs, install a replacement ECU. NOTE: A good throttle position sensor should have resistance of: (1) 9000–15,000 Ohms across terminals A and C. (2) 500 Ohms, moving to 9000–15,000 Ohms as TPS is stroked (measured across terminals A and B).