Industrial — CODE 23 XX — SHIFT SELECTOR

WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 23 XX — SHIFT SELECTOR (Figure 6–6) DIAGNOSTIC CODES Main code 23 indicates a fault with a shift selector or the wiring between a shift selector and the ECU. A. Active Indicator Clearing Procedure: Power down Manual Self-clearing NOTE: Before troubleshooting, read Paragraph 6–6. B. Troubleshooting: 1. Clear the active indicator for code 23 XX. If code recurs, continue to Step (2). 2. Check for a poor connection at the shift selector. NOTE: Code 23 12 can result when the +5V line (wire 124) which powers the shift selector is shorted to ground.

Wire 124 also powers the TPS, OLS, RMR, retarder temperature sensor, and sump oil temperature sensor and is present in all three ECU connectors. 3. Disconnect the selector “S” harness connector from the ECU and from the shift selector and check for opens, shorts, and shorts-to-ground between the shift selector and ECU (refer to Section 4). Repair as needed (refer to Appendix E). 4. If no problem is found with the shift selector connection or wiring, replace the shift selector. 5. If the condition persists, replace the ECU. If replacing the ECU corrects the problem, reinstall the original (bad) ECU to confirm that the problem is in the ECU.

If the original ECU now works, in- spect the ECU connectors for any corrosion or damage which may cause an intermittent condition. If the original problem recurs, reinstall the replacement ECU. Copyright © 2001 General Motors Corp. 6–37 Main Code Subcode Meaning 23 12 Primary shift selector fault — a “cateye” type display may occur 23 13 Primary shift selector mode function fault. Mode change not permitted 23 14 Secondary shift selector fault — a “cateye” type display may occur 23 15 Secondary shift selector mode function fault. Mode change not permitted 23 16 Shift selector display line fault