WTEC III ELECTRONIC CONTROLS TROUBLESHOOTING MANUAL CODE 32 XX — C3 PRESSURE SWITCH (Figure 6–10) Copyright © 2001 General Motors Corp. 6–49 Main code 32 indicates the transmission gear ratio is correct, but the C3 pressure switch is open when it should be closed. NOTE: When an ECU with a version 8 or 8A calibration is used with a pre-TransID transmission, 32 XX codes are set because the ECU sees wire 195 is open. To correct this condition, convert to a TID 1 internal harness or install Adapter P/N 200100 available from St. Clair Technologies. See addresses on Page 1–7. Further TransID (TID) information is in Paragraph 1–11.
Main Code Subcode Meaning 32 00 C3 switch open in low range (MD 3070 or HD 4070 only) 32 33 C3 switch open in third range 32 55 C3 switch open in fifth range 32 77 C3 switch open in reverse range A. Active Indicator Clearing Procedure: • Power down • Manual • Self-clearing NOTE: Before troubleshooting, read Paragraph 6–6. Also, check battery and ECU input voltages. B. Troubleshooting: 1. Disconnect the transmission “T” harness connector at the ECU and the transmission. Check the C3 switch circuit for opens, shorts to other wires, shorts-to-ground, or short-to-battery. If wiring problems are found, isolate and repair.
The C3 pressure switch closes at 206.8 ± 48 kPa (30 ± 7 psi); resistance should be 2 Ohms maximum when the switch is closed and 20,000 to infinity when the switch is open. Infinity is often indicated as OL (over limit) on a DVOM. 2. If problems are not found in the external harness, drain the fluid, remove the control module, and check the internal harness for opens, shorts between wires, or shorts-to-ground (refer to the proper transmission Service Manual). If wiring problems are found, isolate and repair (see Appendix E, Paragraph 1–9). 3. If no wiring problems are found, replace the C3 pressure switch (refer to transmission Service Manual). 4.
If the problem recurs, use a spare wire, if available, or provide a new wire (St. Clair P/N 200153 may be used for this purpose) for the C3 pressure switch circuit. 5. If the problem recurs again, replace the internal harness. CAUTION: Using an unmatched ECU/CIN combination may result in additional codes being set or in transmission clutch damage. Using an ECU from another vehicle is not a recommended procedure where the test will involve driving the vehicle. This is because the stored adaptive information is tuned to the original vehicle's transmission and those adaptive settings may not perform as expected in another vehicle.
Transmission performance could be worse and damage to the clutches may occur. Main Code Subcode Meaning 32 00 C3 switch open in low range (MD 3070 or HD 4070 only) 32 33 C3 switch open in third range 32 55 C3 switch open in fifth range 32 77 C3 switch open in reverse range