. OPERATION EXPLANATION OF COMPONENTS the the 3 - 67 METHOD OF OPERAT With the FA CE vents, it is possible to a djust the direction of th e air flow and to turn it on However, do not set to th e FACE mode with the vent s closed. COOLING 1. 2. 3. 4. 5. 6. 7. 1. Press O N/OFF switch (1) to turn on the air conditioner po 2. Press fa n switch (2) t o set the air fl ow to the maximum. 3. 4. Press te Press ai mperature co r conditioner ntrol switch (3 switch (4) to s ) to lower the t et to COOLIN emperat G. 5. 6. Press R Press m ECIRC/FRES ode selector H selector sw switch (6) to s itch (5) to set et the vents to to RECI FACE. 7. When th e temperatur e inside the c nd air flow.
ab goes down, set to dow desired temperature a NOTICE If operations are continued f or a long time w ith the air conditioner se t to the lowest tem perature an d minimum air flow, there is danger that th e receiver drie r may freeze. If it freezes an d no cold air co mes out, stop u sing the cooling , and set to a higher temperature and th e maximum air f low. Run for a short time u nder these con ditions, then re turn to the cooli ng operat ion. HEATING 1. 2. 3. 4. 5. 6. 1. Press O N/OFF switch (1) to turn on the air conditioner po 2. Press fa n switch (2) t o set the air fl ow to the maximum. 3. 4.
Press te Press R mperature co ECIRC/FRES ntrol switch (3 H selector sw ) to raise the t itch (4) to set emperat to FRES 5. 6. Press m When th ode selector e temperatu switch (5) to s re inside the et the vents to FOOT. cab goes up, set to desired temperature a nd air flow. REMARK The heating uses the hea t from the eng ine cooling wa ter, so i t is effective onl y when the cooling water