. OPERATION EXPLANATION OF COMPONENTS ACCELERATOR PEDAL GEAR SHIFT LEVER The gear range can be selected with this lever (3) to match the travel conditions. to 3 - 40 This peda l (2) is used to adjust the en It can be o perated freely between the engine low idle position an the full thr D position : ed for normal travel. r is placed in this position, the transmission is shifte ally from 2nd torque converter drive to 7th speed t travel speed of the machine. p body is raised, the shift lever is fixed at 1st. Alway dump body when traveling. mum speed in this position is 70.0 km/h (43.5 MPH).
This is us If the leve r is placed in this position, ally from 2nd torque conve automatic match the travel speed of the machine If the dum p body is raised, the shift l lower the dump body when traveling. The maxi mum speed in this position is REMARK To comply with the EU safety standard s (EN 474-6 5.1.3), if the machin e travels w ith the du mp body not completely lowered, t he transmission is fixed in 1 st and the gear cannot be shifted . R position : ed when traveling in reverse. This is us ed when traveling in reverse This posit ion uses the torque converte r drive. The maximum tra vel speed in this position i s 10.6 km /h (6.6 M PH).
It is impo ssible to travel in reverse if t he dump body is raised. Lower the "FLOAT" position, then set the gearsh ift lever to the "R" position 6 - L posit ion: These po sitions are used in places wh ere it is difficult to travel a t high speed, or when trav eling on soft groun d, or when star ting the machine off on a slo pe when it is loaded. The y are a lso used when goin g downhill if it is needed to u se the braking force of th e engine. While the dump body is raised, the tra nsmission is fixed to the 1 st gea r and is n ot change d. Keep t he dump body lowered d uring travel.