5A4-32 ANTI-LOCK BRAKE SYSTEM (ABS) Chart A-4 Brake Pedal Feed Is Abnormal Step Action Yes No 1 Is the stop light actuated when the brake pedal is depressed? Go to Step 2 Go to Step 3 2 1. Turn the key off. 2. Disconnect EHCU connector. 3. Measure the voltage between J-500 EHCU connector terminals 16 and 1, when brake pedal is depressed. Is the voltage between 9 - 16 V? Go to Step 4 Harness NG between brake SW and EHCU. Go to Step 7 3 Is stop light fuse 12V: F-17, 24V: F-10 normal? Go to Step 5 Replace fuse 12V: F-17, 24V: F-10. Go to Step 7 4 Is there continuity between J-500 EHCU connector terminal 1 to body ground? Go to Step 6 Repair body grounded harness.
Go to Step 7 5 Is the brake SW normal? Repair stop light harness. Go to Step 7 Replace brake SW. Go to Step 7 6 Is the check harness/connector for suspended disconnection? Hydraulic system leakage or air entry Go to Step 7 Repair harness. Go to Step 7 7 Reconnect all components, ensure all components are properly mounted. Was this step finished? Repeat the “Basic and diagnostic flow chart.” Go to Step 7