Isuzu — Diagnostic Trouble Codes (DTCs)

ANTI-LOCK BRAKE SYSTEM (ABS) 5A4-35 Diagnosis BY “ABS” Warning Light Illumination Pattern ON position or if the warning light is actuated during driving, trouble should be diagnosed on a illumination pattern basis as follows: In the event that there is abnormality in the “ABS” warning light illumination pattern while the key is in the Diagnostic Trouble Codes (DTCs) When the warning light in the meter remains ON, the EHCU stores the fault identification and disables the ABS. 1. How to start DTC display: Confirm that the vehicle has come to a complete stop (with the wheels standing still) and that the brake pedal is not depressed.

(Unless these two conditions are satisfied, DTC display cannot be started.) With the key switch OFF and short B-79 diagnosis connector terminal 12 to ground. Then turn the key switch ON. DTCs can be displayed also by TECH 2. No. Condition “ABS” Warning Light Illumination Pattern Diagnostic 1 Warning light is actuated normally Normal 2 Warning light is not lit Warning light lighting circuit trouble→Go to Chart B-1 3 Warning light is actuated while driving Diagnostic trouble codes are stored. Display diagnostic trouble codes and diagnose on a code basis according to the flow charts.