Isuzu — Chart 16 (DTC 64/C0264) Abnormal RR Speed Sensor Signal

ANTI-LOCK BRAKE SYSTEM (ABS) 5A4-51 Chart 16 (DTC 64/C0264) Abnormal RR Speed Sensor Signal Step Action Value(s) Yes No 1 Is there play in the RR wheel bearing? - Go to Step 8 Go to Step 2 2 Is there play in the RR speed sensor/sensor rotor? - Go to Step 9 Go to Step 3 3 Is there powdered iron sticking to RR speed sensor/sensor rotor? - Go to Step 10 Go to Step 4 4 Check the RR speed sensor. (Refer to Chart C-1-4 or TC-1) Is the RR sensor output normal? - Go to Step 5 Go to Step 7 5 Is there a broken tooth or indentation in the sensor rotor? - Go to Step 11 Go to Step 6 6 1. Clear diagnostic trouble code. 2. Test drive and perform system self-check. Does repeat trouble?

- Go to Step 15 Go to Step 14 7 Is there damage or indentation in the speed sensor? - Go to Step 12 Go to Step 13 8 Adjust wheel bearing preload. Is action complete? - Go to Step 16 - 9 Repair or replace speed sensor/sensor rotor. Is action complete? - Go to Step 16 - 10 Repair speed sensor/sensor rotor. Is action complete? - Go to Step 16 - 11 Replace sensor rotor. Is action complete? - Go to Step 16 - 12 Replace RR speed sensor. Is action complete? - Go to Step 16 - 13 Check the RR speed sensor circuit. Refer to Chart 12. Is action complete? - Verify repair - 14 Check for a poor connection and an open circuit on the harness between EHCU and sensor connectors.

Refer to “Note on Intermittents” described in earlier this section. Is action complete? - Go to Step 16 - 15 Replace EHCU. Is action complete? - Go to Step 16 - 16 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? - Go to “Basic diagnostic flow chart.” Go to Step 16