Isuzu — Chart C-1-2 FR Speed Sensor Output Inspection Procedure

5A4-54 ANTI-LOCK BRAKE SYSTEM (ABS) Chart C-1-2 FR Speed Sensor Output Inspection Procedure Step Action Value(s) Yes No 1 1. Turn the key off. 2. Disconnect EHCU connector. 3. Jack up the vehicle, with all wheels off the ground. 4. Measure the AC voltage between J-500 EHCU connector terminals 10 and 11 while turning FR wheel at a speed of 0.5 RPS. Does the DVM display a voltage within the specified value? 200 mV or more Go to Step 5 Go to Step 2 2 1. Disconnect FR sensor connector. 2. Using DVM, measure the resistance between J-74 sensor connector terminals 1 and 2. Does the DVM display a resistance within the specified value? 1.0-2.0 k ohms Go to Step 4 Go to Step 3 3 1.

Locate open circuit, poor connection or short circuit on the harness between EHCU and sensor connectors. 2. Repair the harness. Is action complete? - Go to Step 5 - 4 Replace FR sensor. Is action complete? - Go to Step 5 - 5 1. Reconnect all components, ensure all components are properly mounted. 2. Clear diagnostic trouble code. Was this step finished? - Go to “Basic diagnostic flow chart.” Go to Step 5