5A4-62 ANTI-LOCK BRAKE SYSTEM (ABS) Inspection and Repair 1. Check the speed sensor rotor for damage including tooth chipping, and if damaged, replace the speed sensor rotor. 4. Install a cotter pin through the nut and knuckle and bend it over. If the notch in the nut does not line up with the cotter pin hole in the knuckle, tighten the nut until it does. Do not loosen the nut to line up a notch and the knuckle hole. 5. Apply grease into the hub cap and install it. 0.4N (40g/0.09lbf) 6. Install the disc brake assembly and tighten two bolts to the specified torque. Torque: 221 N m (22.5kgf m/163lb ft) Installation 1. Using a bench press, install speed sensor rotor. 2.
Install spacer onto the knuckle spindle. 3. Apply grease into the outer and inner bearings and install bearings in the hub. 4. Install oil seal into hub and disc assembly and install hub and disc assembly on to the knuckle spindle. Preload Adjustment Adjust the wheel bearing as follows: 1. Tighten the nut until you are unable to manually rotate the hub and disc assembly. 2. Loosen the nut. 3. Attach a spring balancer to one stud. Gradually retighten the nut until the hub and disc assembly bearing is adjusted to the specified preload. Hub bearing preload New Hub Bearing 9.8-24.5N (1-2.5kgf/2.2-5.5lbf) Reused Hub Bearing 4.9-19.6N (0.5-2kgf/1.1- 4.4lbf)